日本无码专区无码二区

  • <small id="qem4m"></small>
  • <strong id="qem4m"><center id="qem4m"></center></strong>
    <menu id="qem4m"></menu>
  • E-mail: sales@gidi-chain.com

    The conveyor chain needs to check and adjust the offset when replacing the sprocket

    2021-04-21 09:53:19

    The tightness of the sprocket of the conveyor chain should be appropriate. Too tight will increase power consumption and the bearings are easy to wear; too loose sprocket is easy to jump and fall off the chain.


    The degree of tightness of the sprocket is: lifted or pressed down from the middle of the sprocket, the distance between the centers of the two sprocket is about 2%-3%. The sprocket should not swing and skew when installed on the shaft. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the deviation can be 1 mm; when the center distance of the sprocket is more than 0.5 meters, the deviation can be 2 mm. However, there must be no friction on the side surfaces of the sprocket teeth. If the two wheels offset too much, it will easily cause chain disconnection and accelerated wear. When replacing the sprocket, you must pay attention to check and adjust the offset. After the sprocket is severely worn, the new sprocket and the new sprocket should be replaced at the same time to ensure good meshing. It is not possible to just replace a new sprocket or new sprocket alone. Otherwise it will cause poor meshing and accelerate the wear of the new sprocket or new sprocket. When the tooth surface of the sprocket is worn to a certain degree, it should be turned over and used in time (referring to the sprocket used with adjustable surface) to extend the use time. The new sprocket is too long or stretched after use, making it difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number. The chain link should pass through the back of the sprocket, the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.


    The sprocket should be filled with lubricating oil in time during work. Lubricating oil must enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear. The old sprocket cannot be mixed with some new sprocket, otherwise it is easy to produce impact in the transmission and break the sprocket. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place. Commonly used sprocket structure, small diameter sprocket is generally made of integral type, medium diameter sprocket is mostly made of spoke type, in order to facilitate handling, installation and weight reduction, holes are made on the spoke plate, and large diameter sprocket can be made Combined type, at this time the ring gear and the wheel core can be made of different materials! For example, C45, stainless steel and other materials.

    0318091458_523764995.jpg


    日本无码专区无码二区
  • <small id="qem4m"></small>
  • <strong id="qem4m"><center id="qem4m"></center></strong>
    <menu id="qem4m"></menu>